USB 8051/AVR programmer

i bought atmega 8L by mistake instead of atmega8.
Is there a way out to construct the ubasp mentioned above eith atmega 8L? (since they cannot be clocked to 16MHz)

Yes you can use it.

for programming 89s52,should i connect jumper j3 ?????????????

Binu,
Could you please help me to get suitable software programmer to program uc AT89s52 using RS232 serial port and serial/USB converter? i 've already tried Easy downloader and failed to program my MCU.

this is realy important for me,
thanks

89s52

Binu,
Could you please help me to get suitable software programmer to program uc AT89s52 using RS232 serial port and serial/USB converter? i 've already tried Easy downloader and failed to program my MCU.

this is realy important for me,
thanks

Hello
How I connect to 8051 with python and send .hex file to 8051 ? I have this programmer fischl.de - USBasp - USB programmer for Atmel AVR controllers

sir can i make programer (jtag, usbasp itself, evk200/500 etc) to program my programer as u said above

please help me

Hello Mr binu

can i use atmega8L instead of atmega8 ? because atmega8 frequency is upto 16mhz but L have max 8mhz? so can i use this circuit with atmega8L with lower crystal value?

Yes you can use Atmega8L. I am also using it.

Hello Mr Binnu

i have build the circuit but it was not successful everything seems correct but i received USB error that "can not recognized usb device and it is not asking for any driver.I used atmega8 and atmega8l both but same error ... i am an experienced person in electronics and i burn main.hex file to both chips but green light is on and nothing happend kindly help me.
Thanks
Kashif Mukhtar