1. You can now buy finished microcontroller project from us, Check out the Store for the complete list of projects.
  2. Need a custom project, Send us some details about your project. So that we can quote the price for it.

chip enable program error

Discussion in 'Microcontrollers' started by skmsaswat, Oct 26, 2012.

  1. skmsaswat

    skmsaswat New Member

    Likes Received:
    0
    Trophy Points:
    0
    hi, I hv bought a 8051+avr usb asp programmer.I am trying to program AT89S52 and using progisp.every time connect the usb and try to erase the microcontroller, it always shows a error message "Chip enable program error".I am a beginner.please any one can say what is the problem and how to correct it
  2. Binu

    Binu Administrator

    Likes Received:
    138
    Trophy Points:
    63
    Did you provide the AT89S52 with proper crystal and power supply?
  3. skmsaswat

    skmsaswat New Member

    Likes Received:
    0
    Trophy Points:
    0
    i am using 12Mhz crystal oscillator. power supply is 5v.
  4. midhulaj

    midhulaj New Member

    Likes Received:
    0
    Trophy Points:
    1
    hello skmsaswat ,u've bought avr usb burner rt if u just provide me a snapshot of ur programer may be i can help u bcoz i had the same problem wen i've started k..u've to modify a little in ur evaluation board
  5. skmsaswat

    skmsaswat New Member

    Likes Received:
    0
    Trophy Points:
    0
    i hv found out the problem.there was some connection problem in the breadboard. now its working.
  6. pradeepgoel044

    pradeepgoel044 New Member

    Likes Received:
    0
    Trophy Points:
    1
    i am also facing chip enable error please help me how to solve it. using at89s2 with 11.0592mhz
  7. Binu

    Binu Administrator

    Likes Received:
    138
    Trophy Points:
    63
    The problem should be at the AT89s52 side, check the clock and power supply.
  8. Rohitsd

    Rohitsd New Member

    Likes Received:
    0
    Trophy Points:
    1
    some 1 plzzz tell me how to remove chip enable program error
    i want 2 program at89s52 using usbasp programmer
    i have connected...

    mosi to 6 of MCU 89s52
    rat to 9
    sck to 8
    miso 7


    how to remove this error ????
  9. Binu

    Binu Administrator

    Likes Received:
    138
    Trophy Points:
    63
    You need to check the power supply, Crystal oscillator and reset line of the microcontroller.
  10. sarwarislammoon

    sarwarislammoon New Member

    Likes Received:
    1
    Trophy Points:
    1
    sometimes this problem can be solve by removing the RC reset circuit ; I mean just ground the reset pin using a 4.7k resistor don't use any capacitor
    but for power on reset this capacitor is necessary so the best way i think is use a 0.1 uf capacitor
    Last edited: Jul 18, 2014
    tarakeswararao likes this.
Loading...

Share This Page

Loading...